Smart features

• 

  Stainless back end

  The bulk of the back end is constructed from stainless steel. This cuts out rust and means the life of your running gear is extended. The flat discs, vanes and spinner tubes are all stainless. They connect to a pair of extremely reliable hydraulic motors. The roller bearings are easily adjustable for you and keep discs firm.

• 

  Industry leading coating protection system

  Every SAM has an advanced new paint procedure for the long-term. This application has been chosen for its hard-wearing toughness. Firstly a blast then a thermal-arc spray followed by the SAM coating difference. This industry leading coating protection system is mega tough stuff!

• 

  Tough rust resistant hopper

  These plastic bins have shown themselves to be very strong and reliable. They are made from UV-protected polyethylene. Fertiliser can be extremely corrosive and the SAM bin prevents that by being rust-free and easy clean. Fertiliser slips down the sides easily and washes off well.

• 

  Consistent spread control

  Setting the rate you wish to spread is simply by rear door adjustment. The double spinner design gives a nice, accurate, even spread pattern for a wide range of product.

• 

  Smart, accurate weighing

  When purchasing your Spreader you can add electronic weigh scales. This mean you can weigh the fertiliser in your bin at any point. They can also be zeroed out. Further information is below. Note: Weigh scales cannot be fitted retrospectively to Spreaders.

• 

  Topcon control system

  You can also add a Topcon control system to replace the standard ground drive. This gives hydraulic floor speed rate and control. This technology means the correct application rate is applied regardless of changes in forward speed or changes in product density. Gives peace of mind for accuracy and reporting.

• 

  Mudguards for added protection

  Standard on all tandem axle machines (except 9 tonne) SAM mudguards are made from UV-protected, high strength polyethylene. They reduce your cleaning and hold up well to abrasive chemical fertilisers.

• 

  Heavy-duty rubber belt

  The 800mm wide rubber floor is two-ply rubber, riveted into corrosion protected steel bars, then welded onto a high-strength chain. Stainless steel skirts run along both sides to prevent striping.

• 

  Coupling with swivel

  A fixed coupling is standard across 4 and 5 tonne Spreaders. These can be upgraded to a swivel coupling if need be. Great if you have large loads and varied terrain. 6 tonne and above have the heavy swivel coupling as standard. When you are using an Auto Hitch you'll require a donut eye on the coupling.

• 

  Internal mesh (Optional Extra)

  This protective mesh protects the belt and running gear from large objects causing damage.

• SAM Spreader in action

• 

  Roll top cover

  These simple to use roll out covers have a heavy-duty canvas on a sturdy framework with a simple bungy system. The cover is rolled up by the handle and tucked out of the way when you are not using it. The roll-top is located at the rear of the machine so that your Spreader is able to be loaded from both sides.